From the Archive: Clown Fish Pumpkin

This post is a re-post from last Halloween. I entered this Pumpkin into a carving contest. 

It didn't win! Can you believe it?

From this...

To this!

Materials:

• pumpkin, preferably medium sized and fairly round
• cereal boxes or other thin cardboard
• bamboo skewers
• craft glue
• scotch tape
• craft paint: orange, black and white
• permanent black marker
• dark and light blue tissue paper
• white card stock or bristol board

Step one:
Wash and dry the pumpkin. Once it is thoroughly dry, figure out which side is the face. On the opposite side (the tail) draw a circle with black marker. Draw some stripes on each side. Draw two eyes and a mouth, The eyes look best oversized. Then draw a large circle around the entire face.

Step two:
Fill in the black stripes with white paint. Fill in the eyes and the mouth. Two or three coats will be needed. One the eyes are dry, paint in the pupils.

Close up shot of the face

Step three:
While the paint is drying, draw out the shapes for the two sides fins and the tail. I based the size of the fins on the size of the pumpkin. Took a bit of trial and error until I was happy with the shape of the fins.

Make two drawings of each piece (the fins will be double sided). Paint all the pieces orange. When the base layer is dry, outline with black and add black lines, shown in the pictures. You will need one dorsal fin (the top), two side fins, and a tail. In this picture I also made some extra front fins, but I didn't end up using them.

Flip one half of each fin over. Tape bamboo skewers to the plain side. I used three skewers for the tail, and two skewers for each fin. Add some glue and sandwhich the two halves together. Let dry. Some touch ups of the black lines may be needed. The hard part is over! Assembly is easy, just stick the skewers into the flesh of the pumpkin. Touch up any areas as needed.

Side View

Back View

Optional:

To make the reef:
I used a lazy susan as the base, and wrapped it with dark blue tissue paper. Next I freehand drew the shapes of the coral on white card stock. Then outlined the shapes in black marker and cut out carefully with small scissors. Next I taped the coral shapes to the base, leaving gaps for the tail and fins. Next I layered the dark and light blue tissue, alternating the colours to make a "bed". I set the pumpkin on top, and it was ready to go!